Home›Ethernet & Layer 2›Digital Ethernet Transmission
Interactive Ethernet fundamentals · Packet-to-physical-layer lab

How Ethernet Turns Bits Into Signals

Follow one byte from PC-A through a switch to PC-B. See the bits become voltage levels, watch the electrical wave travel along the copper wire, and see how the receiver rebuilds the 0s and 1s.

7interactive stages
12,000bits in 1500 bytes
2copper links
6quiz questions
Stage 1 of 7

Swipe the diagram sideways to see both links.

01100110 Copper link 1Copper link 2 PC-ASender Ethernet switchPort 1 in · Port 2 out PC-BReceiver Link 1 · zoomed view of the wire (PC-A → Switch) 3 VHigh = 10 VLow = 0 Time → Bits become a voltage pattern here Link 2 · zoomed view of the wire (Switch → PC-B) 3 VHigh = 10 VLow = 0 Time → A new signal appears after the switch forwards Sent Decoded
Stage 1

Original animation — PC-A → Switch → PC-B

Animated GIF · loops automatically
Original animated teaching GIF showing PC-A sending bits over a copper Ethernet link to a switch, and PC-B receiving them. It uses an illustrative 3 V for binary 1 and 0 V for binary 0.

The animation is a conceptual example of data transmission over copper. It is not a recording of real Ethernet electrical waveforms.

Important technical note: The animation illustrates a binary 1 as 3 V and a binary 0 as 0 V. Actual Ethernet PHYs use standard-specific line coding and signaling rather than a universal 3 V/0 V rule. Each switch port receives and regenerates the signal for its own link.

Quiz

Question 1 of 6

← Back to Ethernet & Layer 2 · WalkOnAWire Home