WalkOnAWire · Enterprise Packet Lab

EVPN MAC Mobility — Watch Host A Move

Four-stage simulation · Type 2 route selection · VXLAN forwarding

Juniper QFX concept · VLAN / L2VNI 1711
Live MAC mobility walkthroughStage 1 of 4

Initial location

Host A moves from Leaf 1 to Leaf 2 across an EVPN-VXLAN fabricTwo QFX VTEP leaves and a spine underlay, with dynamic host attachment and forwarding packet animation.SpineIP underlayLeaf 1VTEP 10.0.0.1QFX · xe-0/0/1Leaf 2VTEP 10.0.0.2QFX · xe-0/0/1Host AAA:...:01EVPN Type 2Control planeRemote VXLAN pathHost attachment and EVPN reachability

Control-plane event

Data-plane implication

Steady forwarding state after each event; transient loss/stale entries are not illustrated.

Packet-level forwarding — before and after the move

Inspect the unchanged inner Ethernet header and the changing outer VXLAN destination. Choose a scenario to animate the packet.

Before move · Host A on Leaf 1Host B (Leaf 2) → Host A (Leaf 1)
Before and after MAC mobility packet forwarding topology Host A and Host B change their illustrative attachment locations when the Before and After controls are selected. SpineIP underlay Leaf 1VTEP 10.0.0.1xe-0/0/1 Leaf 2VTEP 10.0.0.2xe-0/0/1 Host A AA:…:01 Host B BB:…:02 Host A at Leaf 1 · VXLAN destination 10.0.0.1
Host A · destination MAC AA:…:01Host B · source MAC BB:…:02VXLAN outer IP path

Inner Ethernet frame — preserved

Destination MACAA:AA:AA:AA:AA:01
Source MACBB:BB:BB:BB:BB:02
EtherType0x0800 · IPv4
IP payloadHost B → Host A

Outer VXLAN encapsulation

Source VTEP
Destination VTEP
UDP destination4789
VXLAN VNI1711
For a symmetric, cross-fabric comparison, Host B is placed on the opposite leaf in each scenario. This is a separate illustrative traffic setup, not an assertion that Host B automatically moves when Host A moves. The inner IP/MAC endpoint identities remain the same.

MAC Mobility sequence numbers

An illustrated series of single-homed moves; a newer mobility sequence helps select the current MAC origin.

Leaf 1 · seq 0→Leaf 2 · seq 1→Leaf 1 · seq 2→Leaf 2 · seq 3
The initial advertisement may omit the mobility community, interpreted as sequence zero. A larger sequence is normally preferred for a non-sticky, single-homed MAC, subject to additional RFC rules.
What about MAC flapping and duplicate detection?

Rapid repeated moves may indicate loops or duplicate MAC use. RFC 7432 describes a default threshold of five moves in 180 seconds for duplicate detection. Actual Junos detection, configuration, and suppression behavior depend on platform/release and must be verified.

0→1→2→3→4→5
Sequence progression is illustrative, not measured telemetry.

Engineer-level knowledge check

Question 1 of 4

Choose the best answer in each scenario. Your score is tracked as you proceed.